色谱 ›› 2022, Vol. 40 ›› Issue (12): 1049-1063.DOI: 10.3724/SP.J.1123.2022.03041

• 研究论文 • 上一篇    下一篇

磁性三维氮掺杂碳纳米材料对6种双酚类化合物的吸附性能及其在泡腾分散微萃取中的应用

刘婷婷1,2, 王琪1, 叶翰章1, 孔佳1, 李宇浩1, 顾婧婧1, 丁永立1, 张占恩1, 王学东1,*()   

  1. 1.苏州科技大学环境科学与工程学院, 江苏 苏州 215009
    2.江苏省环境科学与工程重点实验室, 江苏 苏州 215009
  • 收稿日期:2022-03-29 出版日期:2022-12-08 发布日期:2022-11-29
  • 通讯作者: 王学东
  • 基金资助:
    江苏省重点研发项目(BE2022733);国家自然科学基金项目(21876125);国家自然科学基金项目(22076134);江苏省自然科学基金项目(BK20211338);苏州市科技局重点研发项目(SS202028)

Adsorption characteristics of six bisphenol compounds on magnetic three-dimensional nitrogen-doped carbon nanomaterials and their use in effervescent reaction-assisted dispersive microextraction

LIU Tingting1,2, WANG Qi1, YE Hanzhang1, KONG Jia1, LI Yuhao1, GU Jingjing1, DING Yongli1, ZHANG Zhan’en1, WANG Xuedong1,*()   

  1. 1. School of Environmental Science and Engineering, Suzhou University of Science and Technology, Suzhou 215009, China
    2. Jiangsu Key Laboratory of Environmental Science and Engineering, Suzhou 215009, China
  • Received:2022-03-29 Online:2022-12-08 Published:2022-11-29
  • Contact: WANG Xuedong
  • Supported by:
    Key Research & Development Project of Jiangsu Province(BE2022733);National Natural Science Foundation of China(21876125);National Natural Science Foundation of China(22076134);Jiangsu Provincial Natural Science Foundation(BK20211338);Key Research & Development Project of Suzhou Sci & Technol Bureau(SS202028)

摘要:

采用简单高温煅烧法成功制备了磁性钴镍基氮掺杂三维碳纳米管与石墨烯复合材料(CoNi@NGC),将其作为吸附剂用于水体中6种双酚类化合物(BPs)的吸附性能和机理研究。将CoNi@NGC复合纳米材料用作萃取介质,运用酸碱泡腾片的CO2强力分散作用,开发了泡腾反应强化的分散固相微萃取前处理方法,结合高效液相色谱-荧光检测(HPLC-FLD)快速定量饮料中痕量BPs。采用扫描电镜、透射电镜、傅里叶红外光谱、氮气吸脱附、X射线光电子能谱和磁滞回线等技术手段对材料形貌结构进行表征,结果显示:该吸附剂成功实现氮元素的掺杂,且具有较大的比表面积(109.42 m2/g)、丰富的孔径及较强的磁性(17.98 emu/g)。吸附剂投加量、pH、温度、时间等因子优化试验表明:当pH=7,在初始质量浓度为5 mg/L的BPs混合溶液中投加5 mg CoNi@NGC, 298 K反应5 min,对双酚M(BPM)、双酚A(BPA)的吸附率分别高达99.01%和98.21%。作用90 min时对双酚Z(BPZ)、BPA、BPM的吸附率近100%。在吸附过程中,BPs与CoNi@NGC之间的整个吸附过程主要受氢键、静电作用和π-π共轭作用共同控制。整个吸附过程符合Freundlich吸附等温线模型和准二级动力学方程,吸附自发进行。进一步将CoNi@NGC作为萃取介质制备成磁性泡腾片,利用泡腾分散微萃取技术高效富集和提取6种盒装饮料中的BPs,优化了影响富集效果的泡腾片的存在与否、洗脱剂种类、洗脱时间、洗脱体积等关键因子,在最佳萃取条件下(pH=7,投加5 mg CoNi@NGC, 2 mL丙酮洗脱6 min),结合HPLC-FLD,新开发的泡腾分散微萃取方法提供的检出限为0.06~0.20 μg/L,定量限为0.20~0.66 μg/L,日内和日间精密度分别为1.44%~4.76%和1.69%~5.36%,在实际样品中不同水平下的加标回收率为82.4%~103.7%,在桃汁中检测到BPA和双酚B(BPB)分别为2.09 μg/L和1.37 μg/L。再生试验表明该吸附材料至少可以重复使用5次以上,显著降低了分析的试验成本。与其他方法相比,该方法具有灵敏度高、萃取速度快、环境友好等优点,在常规食品污染监测中具有较强的应用价值。

关键词: 磁性碳复合材料, 泡腾分散固相微萃取, 高效液相色谱-荧光检测, 双酚类, 吸附剂, 吸附机理

Abstract:

Herein, we successfully prepared magnetic Co/Ni-based N-doped 3D carbon nanotubes and graphene nanocomposites (CoNi@NGC) using a simple high-temperature calcination method. The CoNi@NGC nanocomposites were used as adsorbents to study their adsorption performances and underlying kinetic mechanisms for six types of bisphenol compounds (BPs) in water. They were also used as extractants, and acid-base effervescent tablets were used to enhance extractant dispersion with the aid of vigorous CO2 bubbling. Thus, a novel pretreatment method was developed, denoted effervescent reaction-assisted dispersive solid-phase microextraction (ER-DSM), which was combined with high performance liquid chromatography-fluorescence detection (HPLC-FLD) to rapidly quantify trace-level BPs in several drinks. The morphology and structure of the CoNi@NGC adsorbent were characterized in detail using scanning electron microscopy (SEM), transmission electron microscopy (TEM), Fourier transform infrared spectroscopy (FT-IR), N2 adsorption and desorption (BET-BJH), X-ray photoelectron spectroscopy (XPS), and vibrating sample magnetometry (VSM). The CoNi@NGC nanocomposites were successfully doped with N and exhibited large specific surface areas (109.42 m2/g), abundant pores, and strong magnetic properties (17.98 emu/g).
Key parameters were rigorously optimized to maximize the adsorption performance of CoNi@NGC, including adsorbent dosage, solution pH, temperature, and time. Under the constant conditions of pH=7, 5 mg of CoNi@NGC, initial BP concentrations of 5 mg/L, and 5 min of shaking at 298 K, the adsorption percentages of bisphenol M (BPM) and bisphenol A (BPA) reached respective maxima of 99.01% and 98.21%. Remarkably, those of bisphenol Z (BPZ), BPA, and BPM reached almost 100% after 90 min. The adsorption between the BPs and CoNi@NGC was mainly governed by hydrogen bonds, electrostatic interactions, and π-π conjugation. The entire adsorption process was consistent with Freundlich adsorption and a quasi-second-order kinetic equation, representing spontaneous adsorption. Via integration with HPLC-FLD, ER-DSM was used to rapidly extract and analyze trace-level BPs in six types of boxed drinks. Critical factors were optimized individually, including the type of eluent and elution time and volume, which influenced the enrichment effect. Under the optimized extraction conditions (pH=7, 5 mg CoNi@NGC, elution with 2 mL acetone for 6 min), the limits of detection and quantification of the novel extraction method were 0.06-0.20 and 0.20-0.66 μg/L, respectively. The intra- and inter-day precisions spanned the ranges 1.44%-4.76% and 1.69%-5.36%, respectively, and the recoveries in the actual samples were in the range 82.4%-103.7%. Moreover, the respective residual levels of BPA and BPB in peach juice samples were 2.09 and 1.37 μg/L. Regeneration studies revealed that the CoNi@NGC adsorbent could be reused at least five times, which significantly reduced the cost of evaluation. In summary, compared to other methods, this method displays the advantages of a high sensitivity, rapid extraction, and environmental friendliness, thereby exhibiting considerable potential for use in conventional monitoring of trace-level BPs in food matrices.

Key words: magnetic carbon-based nanocomposite, effervescent reaction-assisted dispersive solid-phase microextraction, high performance liquid chromatography-fluorescence detection (HPLC-FLD), bisphenol, adsorbent, adsorption mechanism

中图分类号: